Im not sure if the bracket that attaches to the transmission is bent or if it is suppose to have a slight lean to it??
This is for a 2g AWD Manual Tranny.
Still in vacuum
2G Sifter Cable Bracket is it bent???
Im not sure if the bracket that attaches to the transmission is bent or if it is suppose to have a slight lean to it??
This is for a 2g AWD Manual Tranny.
I need t-bolt clamps
I can't quite remember how it goes on a 2g, but does it shift okay? Is there any binding when shifting? As long as the cables run pretty straight and don't bend or bind I would think you would be just fine.
"it doesn't give anyone the right to trash the room, trash the property, climb on their roof, ride garbage cans down their stairs, take a shit in their pool, do burn outs in their parking lot, change the lettering on their signs, break bottles in their parking lots, pull your engines and leave anti freeze and oil in their lot, do burnouts on the room carpet with pocket bikes or any of the other destructive fucking idiotic shit that has happened over the years.
GROW THE FUCK UP"
Still in vacuum
Post a pic if you can. I believe on my 2g there is a slight lean.
1991 Mighty max 4G63 swapped
Still in vacuum
Well as it turns out. One of the cables had a real nice kink at the end by the tranny connection. I bought new OEM cable set and a set of torque solutions bushings for the ends also. It shifts like a dream now!!!
Still in vacuum
any pic will be better
Posting Permissions
Reply With Quote